FORD APCM MANUAL PDF

Home  /   FORD APCM MANUAL PDF

OPERATING INSTRUCTIONS for the AUXILIARY IDLE CONTROL MODULEExclusively for Ford Trucks with L DIT Diesel Engines Powertrain Control S. Press any arrow key to toggle Manual RPM Control function. Press ACTIVATE/ DEACTIVATE (FORD OVAL) key to proceed to the next step in programming. inside before operating pto muncie power products, inc. ford apcm manual pdf started finding ford apcm manual, and you are right to find the biggest collection.

Author: Votaur Gokora
Country: Malta
Language: English (Spanish)
Genre: Education
Published (Last): 10 December 2005
Pages: 268
PDF File Size: 10.18 Mb
ePub File Size: 9.79 Mb
ISBN: 506-2-99353-428-5
Downloads: 33249
Price: Free* [*Free Regsitration Required]
Uploader: Zuluran

There are different modes to adjust: Foot off accelerator pedal 6.

Since we cannot actually see what is going on inside the computer More information. Display shows the RPM value associated with the Custom input voltage. Describes how to use a selected menu item. Servo Electronic Servo Solenoid How to read this guide The following shows the symbols used in this Quick start guide with descriptions and examples.

LCD screen displays current engine speed or battery voltage. Check for input signal and source voltage lines. The recommendation is to use Charge Protection mode with Ford alternators. Cut SCP wires can cause this error. Step 1 Page 9. The recommendation is to use Charge Protection mode with Ford alternators.

  CANUTO TABACCO ANALISI MATEMATICA 2 PDF

OPERATING INSTRUCTIONS. for the AUXILIARY IDLE CONTROL MODULE

For other electrical loads: Press the key once to turn on the 12V PTO Control high side driver, and press the key again to turn off.

Section 6 Page 3.

With the software application information shown on the display can be adjusted. The switch is not included in the kit.

For information on what engine speed RPM value corresponds to what custom input voltage Vrefer to Section 9. There are also programmable options for lower and upper limits.

It should be connected to a normally open contact. The PTO output driver will not be allowed to turn on whenever the actual engine speed exceeds the programmed lower limit. In Charge Protection mode, the system battery voltage is monitored and the engine speed, in RPM, is increased so the voltage is maintained and mahual charged as required.

OPERATING INSTRUCTIONS for the AUXILIARY IDLE CONTROL

Locate the mating 4-pin connector under the driver’s side instrument panel and connect. Quality industrial switches with gold contacts are recommended for contact durability due to the low current. Step 1 Program the PTO lower limit. The programmable speed presets range from to RPM. Stop Alert Flasher with G-Force sensor Stop Alert Flasher with Apdm sensor Stop Alert module creates brake light flashing effect to catch attention of the drivers behind to avoid dangerous rear end collision.

  DESARROLLO DEL POTENCIAL HUMANO JUAN LAFARGA PDF

With Automatic Charge Protection programmed, the engine speed will be elevated within a few seconds after programming is exited and the vehicle’s enabling conditions are met. Connect potentiometer to supplied inputs and program module as required.

OPERATING INSTRUCTIONS for the AUXILIARY IDLE CONTROL

Ensure that ALL of the enabling conditions are met: Charge Protection mode can only be activated with all vehicle interlock conditions met, the APCM is for stationary use only. Save and exit programming kanual by pressing the [FORD] key twice.

We are excited to be able to provide this product to you and we are certain that it will fulfill your performance. Be sure to read and follow the installation instructions given in Section 6 and the PTO output specifications in Section 9 before proceeding.